Show more

got the left end of the keyboard model rebuilt; should be a lot easier to maintain with both sides built the same. also, more useful to folks when i publish it.

keyboard with it's final keycaps. done for now, but I need to clean up the designs before I publish them.

meditating on this cat picture to hopefully absorb some of its peaceful energy

also, added another design to thingiverse today; through-hole mount for a humidity sensor: thingiverse.com/thing:3097889

starting to feel... slightly?... competent in fusion 360.

"shitty scissors I don't care if I ruin" is one of my most essential tools

there ain't no party like a sprintf party
'cause a sprintf party don't stop�5P�ۙ��#bV*��d����@w��Ռ-.`�t �c߁��i��EzC8vދ�t�H��V�n�

threw together a screwdriver holder for an Ikea hejne shelf; first design worked perfectly, was very surprised!

saw nodejs 10.10.0 just released and of they don't make it to 10 patch released it will be a tragedy

LaCroix tastes like somebody angrily subtweeting fruit.

waiting on a slow first layer to print, so I can go to bed. hopefully the final version of the right hand keyboard bottom case.

just finished Donut County and it was cute af. you can play through it in a few hours, if something quick sounds good.

everything fits like it's supposed to, except the dang right hand board. so close though!

jock jams 

left half assembled (with some temporary keys). fit issues with the switch plate and the lower case; need to make a few changes, but really good for the first complete assembly.

test build of the left hand side of my keyboard. case design seems good, now to solder up keys and see if the electronics fit!

Show more
Mastodon

Server run by the main developers of the project 🐘 It is not focused on any particular niche interest - everyone is welcome as long as you follow our code of conduct!